12 31 020 Removing and installing or replacing alternator (N52, N52K, N51, N53)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Aluminium-magnesium materials.
No steel screws/bolts may be used due to the threat of electrochemical corrosion.
A magnesium crankcase requires aluminium screws/bolts exclusively.
Aluminium screws/bolts must be replaced each time they are released .
The end faces of aluminium screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Necessary preliminary tasks:
- Switch off ignition
- Disconnect Battery Negative Lead
- Remove Intake Filter Housing
- Remove Alternator Drive Belt
Unlock plug (1) and remove.
Slacken nut (2).
Installation:
For tightening torque refer to 1AZ in 12 31 ALTERNATOR WITH DRIVE AND MOUNTING PARTS .
Release screws and remove alternator (3).
Installation:
Replace aluminium screws.
For tightening torque refer to 2AZ in 12 31 ALTERNATOR WITH DRIVE AND MOUNTING PARTS .