11 00 670 Securing engine in installation position (N51)

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 0 200
00 0 202
00 0 204
00 0 208
11 0 020
64 1 020

WARNING: Danger of injury!

Observe following instructions relating to special tool:

Prior to each use, check the special tools for defects, modifications and operational reliability.
Damaged/modified special tools must not be used!
No changes or modifications may be made to the special tools!
Keep special tools dry, clean and free of grease.

Necessary preliminary tasks:

Secure engine Bonnet/Hood In Service Position
Remove Cowl Panel Cover
Remove Both Tension Struts From Spring Strut Dome
Remove Intake Filter Housing
Remove ignition coil cover

Release screws (1, 2).

Remove bulkhead (3).

Installation:

Make sure bulkhead is correctly seated.

M6x20 screw must be fitted in middle.

Fig 1: Release Screws And Bulkhead

Courtesy of BMW OF NORTH AMERICA, INC.

Only on E92, E93:

Unclip two cover caps (1) on left and right of side panel screw connection with special tool 64 1 020.

Installation:

Replace damaged cover caps.

Fig 2: Special Tool (64 1 020) And Cover Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble cross member 00 0 200 with special tools 00 0 202, 00 0 204, 00 0 208.

Fig 3: Special Tool (00 0 200)

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Use towing hook (72 15 8 108 670).

Fig 4: Towing Hook (72 15 8 108 670)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Avoid a change of engine position in the transverse or longitudinal direction.

Always make sure there is sufficient clearance between the engine (or its attachment parts) and the body.

IMPORTANT: Risk of damage!

With the aid of an assistant and the supports, place cross member 00 0 200 on the screw connections of the side panels.

Screw in towing hook (1) and tighten down to approx. 30 Nm.

Secure special tool 11 0 020 to spindle 00 0 202.

Fit suitable chains to special tool 11 0 020 and attach to towing hook (1) or engine lifting eye.

Fig 5: Special Tools (00 0 202), (00 0 200) And (11 0 020)

Courtesy of BMW OF NORTH AMERICA, INC.

WARNING: Danger of injury!

Tighten down all adjusting screws and nuts on cross member 00 0 200.

Fig 6: Special Tool (00 0 200)

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Raise engine approx. 10 mm with cross member.

Installation:

Replace self-locking nuts.

For tightening torque refer to 22 11 2AZ in 22 11 ENGINE SUSPENSION .

Fig 7: Nut

Courtesy of BMW OF NORTH AMERICA, INC.