00 11 237 Checking/topping up fluid level in automatic transmission (GA6HP19Z/6HP19Z) AWD

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Use only the approved Transmission Fluid. .

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Remove exhaust system bracket (1).

Fig 1: Identifying Exhaust System Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Tighten down filler plug using

Hexagon wrench 8 A/F
torque wrench
Socket 8 A/F

Fig 2: Locating Filler Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Topping up transmission fluid after a repair:

Stand vehicle on a level surface and secure against rolling off.

Undo filler plug (1).

Installation:

Replace sealing ring.

Top up transmission fluid until it emerges from filling orifice.

Start engine.

Replenish transmission fluid until it emerges from filling orifice.

Screw in filler plug (1).

For tightening torque refer to 7AZ in 24 11 TRANSMISSION HOUSING, TRANSMISSION OIL SUMP (5AZ-7AZ) .

Press brake pedal to floor and shift through gears 1 to 6 several times at idle speed. Then shift to "P" position (Park).

Then check fluid level.

Fig 3: Locating Filler Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Checking fluid level:

Connect BMW Diagnosis and Information System (DIS) or BMW MoDiC to vehicle.
Call up Service functions (drive).
Carry out fluid level check in accordance with instructions.