Checking fluid level

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Check fluid level with engine switched off at expansion tank of power steering/ride-height control system. The fluid temperature should be approx. 20°C here.

Ensure that the cap is fully screwed in prior to the fill level check.

If necessary, add hydraulic fluid (refer to Service Information Operating Fluids ) up to Max. marking (1).

IMPORTANT: If the fluid level has dropped to the Min. marking (2), you must check the power steering and ride-height control for leaks and issue a separate invoice for this work.

It is not enough merely to top up the fluid.

Fig 1: Hydraulic Fluid Level Minimum And Maximum Markings

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: To avoid mix-ups when filling with hydraulic fluid, mark the fluid reservoirs or their caps with identification marks.

ATF Automatic transmission fluid

CHF Pentosin CHF11S

Fig 2: Fluid Reservoirs Caps With Identification Marks

Courtesy of BMW OF NORTH AMERICA, INC.