12 51 150 Removing And Installing/Replacing Wiring Harness Section For Fuel Injectors On Left Or Right (N62, N62TU)

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW X5, 2010 BMW 650i, 2009 BMW X5, 2009 BMW 650i, and 2008 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Disconnect battery negative lead
Remove ACOUSTIC COVER
Remove ignition coil cover

NOTE:

The procedure is identical for both sides.

Unfasten screws.

Unlock plug (1) and remove.

Remove positioning motor for eccentric shaft. See REMOVING AND INSTALLING/REPLACING SERVOMOTOR FOR LEFT ECCENTRIC SHAFT (N62/N62TU) and REMOVING AND INSTALLING/REPLACING SERVOMOTOR FOR RIGHT ECCENTRIC SHAFT (N62/N62TU) .

Unlock plugs on fuel injectors and disconnect.

Remove wiring harness.

Fig 1: Locating Plug And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Check function of DME.