11 72 000 Removing And Installing/Replacing Air Pump (N62)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 750i, 2008 BMW 750Li, and 2008 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

Remove upper section of intake filter housing.

Release retaining screws on coolant expansion tank.

Remove suction filter housing.

Remove raw air housing.

Unlock and disconnect pressure and suction lines (1).

Loosen screws (2).

Loosen screw (3).

Fig 1: Identifying Suction Lines And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove front splash guard.

Remove trim panel at bottom right.

Unlock plug (1) and remove.

Unscrew bolt (3).

Remove air pump (2).

Fig 2: Identifying Air Pump Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts.

Unclip plug (1).

Remove holder from air pump.

Fig 3: Locating Air Pump Nut

Courtesy of BMW OF NORTH AMERICA, INC.