11 21 Crankshaft and Bearings S85
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW M5, 2009 BMW M6, 2009 BMW M5, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
TECHNICAL DATA - CRANKSHAFT AND BEARINGS S85
| Ground sizes of main bearing journals | - | main bearing journal |
| Original (designation Y) | mm | 59.984+0.006 |
| Original (designation G) | mm | 59.977+0.006 |
| Original (designation V) | mm | 59.971+0.006 |
| Grinding stage 1 (designation B1) | mm | 59.734+0.006 |
| Grinding stage 1 (designation B2) | mm | 59.727+0.006 |
| Grinding stage 1 (designation B3) | mm | 59.721+0.006 |
| Crankshaft bearing clearance, radial | mm | - |
| Max. permitted runout at center crankshaft journal | mm | 0.15 |
|
IMPORTANT:
follow repair instructions
|
- | When using new parts, observe BMW EPC (Electronic Parts Catalog) |
TECHNICAL DATA - CRANKSHAFT AND BEARINGS
| Ground sizes of main bearing journals | - | Guide bearing journal |
| Original (designation Y) | mm | 59.984+0.006 |
| Original (designation G) | mm | 59.977+0.006 |
| Original (designation V) | mm | 59.971+0.006 |
| Grinding stage 1 (designation B1) | mm | 59.734+0.006 |
| Grinding stage 1 (designation B2) | mm | 59.727+0.006 |
| Grinding stage 1 (designation B3) | mm | 59.721+0.006 |
| Crankshaft bearing clearance, radial | mm | - |
| Max. permitted runout at center crankshaft journal | mm | 0.15 |
|
IMPORTANT:
follow repair instructions
|
- | When using new parts, observe BMW EPC (Electronic Parts Catalog) and TIS information |