LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Air Bag Restraint Systems) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> All AIR Bags & Seat Belt Pretensioners

All AIR Bags & Seat Belt Pretensioners

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 BMW M3, 2003 BMW 330xi, 2003 BMW 330i, 2003 BMW 330Ci, and 2003 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Move vehicle outdoors to a remote area, away from workshop and people. Disconnect and shield negative battery cable. Close doors and open windows, sunroof and trunk. Ensure all air bag modules are securely installed. Remove loose objects from around air bag modules.
  2. Disconnect air bag control unit 30- or 50-pin harness connector. Air bag control unit is located underneath center console between front seats. Attach Firing Device (62 1 270) and Cable (62 1 210) to 30-pin connector or Cable (62 1 310) to 50-pin connector. Connect firing device to 12-volt battery placed 33 feet (10 m) to rear of vehicle.
  3. Press firing device switch to deploy air bags and pretensioners. If Cable (62 1 310, 50-pin connector) is used, only air bags and pretensioner on one side of vehicle will deploy. To deploy remaining air bags and pretensioner, connect cable to free connector and repeat this step.
scientia non olet · About LEMON Manuals