LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Air Bag Restraint Systems) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> All AIR Bags & Seat Belt Pretensioners

All AIR Bags & Seat Belt Pretensioners

WARNING: This page is about a different car, the 2003 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Move vehicle outdoors to a remote area, away from workshop and people. Disconnect and shield negative battery cable. Close doors and open windows, sunroof and trunk. Ensure all air bag modules are securely installed. Remove loose objects from around air bag modules.
  2. Disconnect air bag control unit harness 30- or 50-pin connector. Air bag control unit is located underneath center console between front seats. Attach Firing Device (62 1 270) and Cable (62 1 210) to 30-pin connector or Cable (62 1 310) to 50-pin connector. Connect firing device to 12-volt battery placed 33 feet (10 m) to rear of vehicle.
  3. Press firing device switch to deploy air bags and pretensioners. If Cable (62 1 310, 50-pin connector) is used, only air bags and pretensioner on one side of vehicle will deploy. To deploy remaining air bags and pretensioner, connect cable to free connector and repeat this step.
scientia non olet · About LEMON Manuals