11 13 Oil Pan (N52)
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2008 BMW Z4, 2008 BMW 328xi, 2008 BMW 328i, 2008 BMW 323i, and 2007 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
OIL PAN TIGHTENING SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Oil drain plug | N52 | M12 x 1.5 | 25 Nm | |
| 2AZ Oil pan on engine block Aluminium oil sump Aluminium screws/bolts are marked with blue paint. |
N52 | M8x26 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 90 ° | |||
| 3AZ Oil pan on engine block Aluminium oil sump Aluminium screws/bolts are marked with blue paint. |
N52 | M8x92 M8x112 |
Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 180 ° | |||
| 4AZ Oil pan on engine block Sheet metal oil sump Aluminium screws/bolts are marked with blue paint. |
N52 | M8x24 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 90 ° | |||
| 5AZ Oil deflector to crankcase lower section Aluminium screws/bolts are marked with blue paint. |
N52 | M6x20 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Torque angle | 90 ° |