12 61 280 Removing and installing/replacing oil pressure sensor (N52, N52K, N51, N54, N53)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2008 BMW Z4, 2008 BMW 328xi, 2008 BMW 328i, 2008 BMW 323i, and 2007 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Switch off ignition
- N52, N52K, N51, N53 only:
- Remove Ignition Coil Cover
- N54 only:
- Remove Intake Filter Housing
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Installation location:
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Unlock plug (1) and remove.
Release oil pressure sensor (2).
For tightening torque refer to 12 61 1AZ in OIL PRESSURE - OIL TEMPERATURE .
Installation:
Check engine oil level, top up engine oil if necessary.