12 31 020 Removing and installing or replacing alternator (N52, N52K, N51, N53)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2008 BMW Z4, 2008 BMW 328xi, 2008 BMW 328i, 2008 BMW 323i, and 2007 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Aluminium-magnesium materials.
No steel screws/bolts may be used due to the threat of electrochemical corrosion.
A magnesium crankcase requires aluminium screws/bolts exclusively.
Aluminium screws/bolts must be replaced each time they are released.
The end faces of aluminium screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage).
Necessary preliminary tasks:
- Switch off ignition
- Disconnect Battery Negative Lead
- Remove Intake Filter Housing
- Remove Alternator Drive Belt
Unlock plug (1) and remove.
Slacken nut (2).
Installation:
For tightening torque refer to 12 31 1AZ in ALTERNATOR WITH DRIVE .
Release screws and remove alternator (3).
Installation:
Replace aluminium screws.
For tightening torque refer to 12 31 2AZ in ALTERNATOR WITH DRIVE .