13 53 240 Replacing complete injection pipe (N52/N52K)

Special tools required: 

• 13 5 281

Necessary preliminary tasks: 

• Read out fault memory of DME control unit
• Switch off ignition
• Remove clean air pipe
• Remove ignition coil cover

Recycling 

Fuel escapes when fuel line is detached. Catch and dispose of escaping fuel.

Observe country-specific waste-disposal regulations.

N52K only: 

Unclip plug connection (1) from holder (2) and disconnect.

Unclip wiring harnesses from holder (2) and connector strip (3).

Disconnect holder (2) from injection pipe.

Fig 1: Identifying Plug Connection And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Remove protective cap from compressed air valve.

Fig 2: Identifying Compressed Air Valve Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Connect compressed air line (1) to compressed air valve.

Blow fuel back into tank with a short blast of compressed air (max. 3 bar).

Fig 3: Identifying Compressed Air Line

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and detach fuel line (1).

Detach connector strip (2) in direction of arrow.

Release screws.

For tightening torque refer to 13 53 1AZ in 13 53 FUEL INJECTION NOZZLES AND PIPES .

Remove injection pipe (3).

Fig 4: Detaching Fuel Line And Removing Injection Pipe

Courtesy of BMW OF NORTH AMERICA, INC.

Seal fuel hose with special tool 13 5 281.

Fig 5: Identifying Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out retainers (1).

Pull fuel injectors out of injection pipe.

Installation: 

Replace sealing rings on fuel injectors and coat with anti-friction rubber coating.

Fig 6: Identifying Lever Out Retainers

Courtesy of BMW OF NORTH AMERICA, INC.