22 11 110 Replacing left engine support arm (N51/N52)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 BMW Z4, 2007 BMW Z4, 2006 BMW Z4, 2006 BMW 330xi, and 2006 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Secure engine in installation position
- Remove intake filter housing
- Remove manifold support
- Remove stiffening strut
- Remove underbody protection at front and rear
Release grounding strap from engine support arm.
Release screw (1).
Release corrugated tube (2) from retainer.
Release screws (3).
Remove engine support arm.
Installation:
Aluminium screws/bolts must be replaced.
Tightening torque 22 11 3AZ