24 34 021 Replacing sealing sleeve for transmission housing (GA6HP19Z)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2008 BMW 328xi, 2008 BMW 328i, 2008 BMW 323i, 2007 BMW 328xi, and 2007 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

24 2 390

IMPORTANT: After completion of work, check Transmission Oil Level .

Use only approved Transmission Fluid .

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

Remove heat shields.
Remove Transmission Cross-Member .
Remove Transmission Sump .

IMPORTANT: Support transmission with workshop hoist.

Unlock and disconnect plug (1) by turning.

Fig 1: Disconnecting Plug With Turning

G04726084

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 24 2 390 in sealing sleeve (1).

Fig 2: Identifying Special Tool (24 2 390) And Sealing Sleeve

G04726133

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock sealing sleeve with slide (1).

Fig 3: Identifying Sealing Sleeve

G04726136

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Note position of sealing sleeve.

Pull out sealing sleeve (1).

Installation:

Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing sleeve.

Lug on sealing sleeve must not be damaged!

Fig 4: Pulling Out Sealing Sleeve

G04726137

Courtesy of BMW OF NORTH AMERICA, INC.