24 31 011 Replacing torque converter flange shaft seal (GA6HP19Z)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2008 BMW 328xi, 2008 BMW 328i, 2008 BMW 323i, 2007 BMW 328xi, and 2007 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 1 450
24 0 200
24 2 351
24 2 352
24 2 353
24 2 400

Necessary preliminary tasks:

Remove Automatic Transmission .

IMPORTANT: After completion of work, check Transmission Oil Level .

Use only approved Transmission Oil .

Failure to comply with this instruction will result in serious damage to the transmission.

Secure transmission with special tool 24 0 200 to assembly stand 00 1 450.

Remove Torque Converter .

NOTE: Read and comply with note on Installation Of Transmission Retaining Bridge .

Fig 1: Identifying Special Tool (24 0 200)

G04726128

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 24 2 353 to drive shaft (1).

Fig 2: Identifying Special Tool (24 2 353) To Drive Shaft

G04726129

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 24 2 351 until it is firmly connected with shaft seal.

Screw in special tool 24 2 352 to remove shaft seal.

Fig 3: Identifying Special Tool (24 2 351) And (24 2 352)

G04726130

Courtesy of BMW OF NORTH AMERICA, INC.

Oil sealing lip on shaft seal.

Drive in shaft seal (1) with special tool 24 2 400 as far as it will go.

Fig 4: Identifying Special Tool (24 2 400) And (24 2 360)

G04726131

Courtesy of BMW OF NORTH AMERICA, INC.