24 00 050 Installing replacement transmission (GA6HP19Z)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2008 BMW 328xi, 2008 BMW 328i, 2008 BMW 323i, 2007 BMW 328xi, and 2007 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Drain automatic transmission fluid at oil drain plug.

For tightening torque refer to 24 11 6AZ in 24 11 TRANSMISSION HOUSING, TRANSMISSION OIL SUMP .

IMPORTANT: After completion of work, program transmission control unit.

Recycling:

Catch and dispose of escaping transmission fluid.

Observe country-specific waste-disposal regulations

IMPORTANT:

Before installing replacement transmission, always Flush Transmission Fluid Cooler Together With Lines .
After completion of work, check Transmission Fluid Level .
Replacement transmission is supplied filled with transmission fluid.

Use only the approved Transmission Fluid .

Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks:

Remove Automatic Transmission .

Release bolts.

Remove and convert transmission bearing block (1).

For tightening torque refer to 24 71 6AZ in 24 71 TRANSMISSION MOUNTS .

Fig 1: Identifying Transmission Bearing Block And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Convert transportation lock (1).

Convert all cable holders.

Convert all seal plugs.

Convert protective cap on output shaft.

IMPORTANT: After removing transportation lock, secure torque converter against slipping out.

Transmission identification:

on type plate

Fig 2: Identifying Transmission Transportation Lock
Courtesy of BMW OF NORTH AMERICA, INC.