25 11 111 Replacing shift rod joint
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2008 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Release propeller shaft at transmission and centre mount. Tie propeller shaft to one side.
Tasks are described in Removing Propeller Shaft .
- Remove transfer case (AWD)
Lift off retainer (1).
Disconnect shift rod (2).
Installation:
Grease shift rod.
Grease, refer to BMW Service Operating Fluids .
Make sure shims (3) are in correct position.
Lever spring washer (1) out of groove and push a little towards rear.
Press dowel pin (2) upwards/downwards out of shift rod joint and remove shift rod joint.
Installation:
Grease ball of selector shaft.
Grease, refer to BMW Service Operating Fluids .
Replace spring washer (1).
Installation:
Check rubber ring (1) in shift rod joint (2) and replace if necessary.