32 41 100 Removing and installing/replacing belt pulley on vane pump for power steering
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2008 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry out preliminary work as described in the document "Replacing drive belt
".
Slacken bolts (1)
Relieve tension on Drive Belt and remove from belt pulley (2).
Unscrew bolts (1) and remove belt pulley (2).
Installation:
Lettering on belt pulley (2) must point forwards.
For tightening torque refer to 32 41 3AZ in 32 41 PUMP AND OIL SUPPLY .