31 35 000 Removing and installing/replacing front stabilizer

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 335i, 2008 BMW 328i, 2008 BMW 323i, 2007 BMW 335i, and 2007 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: To avoid complaints being made by the customer about noise (e.g. grating), set the car on its wheels and tighten down the stabilizer mounting to specified torque.

Necessary preliminary tasks:

Remove Front Assembly Underside Protection
Remove Stabilizer Link On Both Sides From Stabilizer

Release screws (1) and remove brackets.

Release nuts (2); if necessary, grip screws after repair.

Remove stabilizer (3); if necessary, press off front axle carrier with a suitable tool.

Installation:

Check Rubber Mount On Both Sides For Damage , replace if necessary.

Replace self-locking nuts (do not tighten down).

Set car on its wheels and tighten down nuts. For tightening torque refer to 31 35 1AZ in 35 STABILIZER BAR .

Fig 1: Identifying Stabilizer, Screws And Nut

G04726312

Courtesy of BMW OF NORTH AMERICA, INC.

Repair solution for studs:

Release screw (1).

Raise locking nut (2) in area of bore and detach from front axle carrier.

Installation:

Replace locking nut.

For tightening torque refer to 31 12 1AZ in 31 12 CONTROL ARMS AND STRUTS .

Drive out studs (3) in upwards direction and remove/feed out through an opening in front axle carrier.

Insert new screws from above.

Fig 2: Identifying Front Stabilizer Locking Nut, Mounting Nut And Studs

G04726313

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove Rubber Mount On Both Sides From Stabilizer .