31 12 080 Removing and installing/replacing both tension struts

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 335i, 2008 BMW 328i, 2008 BMW 323i, 2007 BMW 335i, and 2007 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove both Front Wheels
Remove front assembly underside protectionFront Assembly Underside Protection

Release nut (1); if necessary, grip at Torx socket (T40).

Installation:

Keep tension strut to swivel bearing connection clean and free from oil and grease.

Replace self-locking nut.

For tightening torque refer to 31 12 2AZ in 31 12 CONTROL ARMS AND STRUTS .

Fig 1: Identifying Tension Strut Mounting Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt (1) and remove tension strut.

Installation:

Raise locking nut (2) in area of bore, detach from front axle carrier and replace.

Tighten bolt connection in normal position.

For tightening torque refer to 31 12 1AZ in 31 12 CONTROL ARMS AND STRUTS .

Fig 2: Identifying Tension Strut Locking Nut And Mounting Bolt

Courtesy of BMW OF NORTH AMERICA, INC.