34 41 000 Removing and installing / replacing handbrake lever

Special tools required: 

• 32 1 030

Necessary preliminary tasks: 

• Remove Airbag Control Unit

After completing work:

• Adjust Handbrake 

Release handbrake lever.

Lock adjuster unit (ASZE).

Using special tool 32 1 030, press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).

Installation: 

Unlock adjuster unit (ASZE).

Lever out restraining hook (2) with a suitable screwdriver.

Restraining hook (2) must detach from stop (1) of adjusting spring.

Fig 1: Identifying Special Tool (32 1 030), Retaining Hook And Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

For tightening torque refer to 34 41 5AZ in 34 41 PARKING BRAKE .

Remove bracket for centre console (2).

Fig 2: Identifying Centre Console And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect cable (1) from handbrake check switch.

Unclip cable bracket (2) at point (3).

Remove cable bracket and place forward.

Fig 3: Identifying Cable Bracket And Point

Courtesy of BMW OF NORTH AMERICA, INC.

Press retainer (1) in balance arm (2) forward in direction of arrow.

Detach handbrake Bowden cables (3) from balance arm (2).

Fig 4: Identifying Retainer, Balance Arm And Bowden Cables

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) and remove handbrake lever (2).

Installation: 

Replace self-locking nuts.

For tightening torque refer to 34 41 1AZ in 34 41 PARKING BRAKE .

Handbrake lever and adjustment unit (ASZE) are only exchanged completely as a single unit.

Fig 5: Identifying Handbrake Lever And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.