34 32 951 Replacing rear left or right brake hose (between rear axle carrier and body)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2008 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 34 3 170
Necessary preliminary tasks:
- Read and comply with General Information.
- Remove Rear Left Wheel
NOTE:
After completing work:
- Bleeding Braking System
Press clutch pedal down to floor and secure with pedal support.
NOTE:
The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
IMPORTANT:
Grip brake hose at square drive to prevent connecting piece from turning in retaining bracket.
Never twist brake hose (3) when installing it and avoid all contact with parts attached rigidly to the body.
Disconnect brake hose from brake line (1).
Detach brake hose from brake line (2) and remove brake hose (3).
Installation:
For tightening torque refer to 34 32 1AZ in34 32 BRAKE LINES .
Installation:
Tighten brake line using torque wrench (Hazet 6282-1CT with reversible ratchet head) and special tool 34 3 170.