35 31 000 Removing and installing or replacing clutch pedal

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2008 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove PEDAL TRIM .

Disconnect return spring (1).

Press end of pin (2) together with offset pliers and press out pin.

Detach locking clip (3) and pull clutch pedal off bearing block.

Installation:

Replace locking clip (3).

Locking clip (3) must be seated with both legs in the pin groove.

Fig 1: Identifying Return Spring And Locking Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check bearing bushings (1) and replace if necessary.

Lightly grease bearing bushings (1).

Fig 2: Identifying Bearing Bushings

Courtesy of BMW OF NORTH AMERICA, INC.