37 14 512 Replacing rear ride-height sensor

WARNING: This page is about a different car, the 2006 BMW 330xi, 2006 BMW 330i, 2006 BMW 325xi, 2006 BMW 325i, and 2006 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release nut (1) and disconnect jointed rod (2).

Installation:

Replace self-locking nut.

Tightening torque 37 14 3AZ.

Disconnect plug connection (3).

Release bolt (4) and remove ride-height sensor with bracket.

Fig 1: Identifying Jointed Rod And Self-Locking Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Align bracket to corresponding bore hole (arrow) in rear axle carrier.

Tightening torque 37 14 2AZ.

Replacement:

Release screws (1) and remove ride-height sensor from bracket (2).

Installation:

Sensor lever (3) must point from ride-height sensor in direction of screw fastening point (arrow) of bracket.

Tightening torque 37 14 1AZ.

Fig 2: Identifying Ride-Height Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Check headlight adjustment, correct if necessary