41 34 041 Tail Panel Complete Replacement

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Read contents of Body, General.

Use only approved Spot-Welding Apparatus for repairs!

Following new body parts are required:

(1) Rear trim

Fig 1: Identifying Rear Trim
Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Open brazed joints in areas (2).

Fig 2: Identifying Weld Joints And Brazed Joints Area (1 Of 3)

G04726933

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Fig 3: Identifying Weld Joints Area (2 Of 3)

G04726934

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part:

Open weld joints in areas (1).

Remove reinforcements (2).

NOTE: This work step is omitted if the rear side panels are replaced at the same time.

Fig 4: Identifying New Part Weld Joints Area And Reinforcements (3 Of 3)

G04726935

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide in rear trim (1) from bottom upwards.

Fig 5: Identifying Rear Trim Installation

G04726936

Courtesy of BMW OF NORTH AMERICA, INC.