41 61 000 Hood/Bonnet Removal And Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Read contents of Body, General.

Necessary preliminary tasks:

Disconnect all cable plug connections

IMPORTANT: For the following work step, secure the engine hood against falling closed.

Disconnect gas-pressure damper from engine hood (1).

Loosen screws (2).

Release screws (3).

For tightening torque refer to 41 61 1AZ.

NOTE: This work step must be carried out with a second person assisting.

Remove hood lid.

Fig 1: Identifying Engine Hood Gas-Pressure Damper And Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.

If this is not possible, Adjust Engine Hood.