41 00... Stamping Vehicle Identification Number

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

41 0 000
41 1 140
41 1 141
41 1 142

NOTE: If the stamped vehicle identification number is removed during repair work, it must be stamped in again.

Read and comply with General Information.

Necessary preliminary tasks:

Remove Front Right Spring Strut
Remove rubber base from guide plate 41 1 141

Special tool kit 41 1 140 for stamping vehicle identification number consists of:

Guide plate 41 1 141

Counter-plate 41 1 142

Fig 1: Identifying Special Tool (41 1 141) And (41 1 142)

G04726781

Courtesy of BMW OF NORTH AMERICA, INC.

Position counter-plate 41 1 142 at bottom on spring strut dome.

Position guide plate 41 1 141 at top on spring strut dome and tighten bolts (1) by hand.

Fig 2: Identifying Special Tool (41 1 141), (41 1 142) And Bolts

G04726782

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten bolt (1) until counter holder 41 1 142 rests on spring strut dome.

Fig 3: Identifying Special Tool (41 1 142) And Bolt

G04726783

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screws (1).

Fig 4: Identifying Special Tool (41 1 141), (41 1 142) And Screws

G04726782

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The illustration is a schematic representation and is to be applied to the relevant vehicle type.

Insert punch numbers 41 0 000 (1) individually into guide plate (2) and stamp vehicle identification number.

Fig 5: Identifying Punch Numbers And Guide Plate

G04726785

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: In the event of component or body replacement by the workshops/garages, clearly delimit the vehicle identification number at front and rear by stamping a "+" in place of the BMW emblem.

Note national regulations.