51 71 447 Removing and installing or replacing panel for cover on left or right side member

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Detach wheel arch cover from Front /Rear side member cover

Release screws (1).

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip panel (1) at holders (2) in direction of arrow and remove.

Fig 2: Identifying Panel And Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Before installation, soak holders (1) in water.

If necessary, detach holders (1) from body and fit on panel (3).

If necessary, detach grommets (2) from holders (1) and place on body.

If necessary, replace faulty holders (1) and grommets (2).

Fig 3: Identifying Panel, Grommet And Holder

Courtesy of BMW OF NORTH AMERICA, INC.