51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left (driver side)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Front Entrance Cover Strip (Inside)
Remove Trim Panel For Pedal Assembly.

Detach mucket (1) in area of side trim panel (2).

Unscrew bolt (3).

Remove hood/bonnet release lever (4) from side trim panel (2).

Fig 1: Identifying Mucket, Trim Panel, Hood/Bonnet Release Lever And Bolt

G04728519

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Unclip side trim panel (4) in each case in direction of arrow at retaining points (2 and 3).

If necessary, disconnect associated plug connection and remove side trim panel (4).

Fig 2: Identifying Screw, Side Trim Panel And Retaining Points

G04728521

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bore.

If necessary, replace faulty clips (1).

Position side trim panel (2) preinstalled with clips (1) on associated bores and clip into place.

Replacement:

Remove Switch For Unlocking Rear Lid.

Fig 3: Identifying Clips And Side Trim Panel

G04728522

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement on right-hand drive up to model year 2005:

NOTE: Because of altered locators on side trim panel and trim panel for pedals from model year 2005, the trim panel for pedals must be reworked.

Cut off ribs (1) on trim panel for pedals (2) flat with scalpel.

Fig 4: Identifying Ribs And Pedals

G04728523

Courtesy of BMW OF NORTH AMERICA, INC.