51 22 225 Removing and installing/replacing inside door opener of rear left or right door

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Rear Door Trim Panel

Unhook Bowden cable for release lever:

Tighten release lever (1).
Lever out lock (2).
Detach Bowden cable (3) towards rear/top.

Installation:

For fitting, press release lever (1) fully onto door trim panel.

Fig 1: Identifying Bowden Cable, Lock And Release Lever

G04728325

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: On initial installation there is no screw in area (A).

If necessary, release screw in area (A).

Release catches (1) and remove door opener (2).

Installation:

Fig 2: Identifying Screw Area, Catches And Door Opener (1 Of 2)

G04728326

Courtesy of BMW OF NORTH AMERICA, INC.

Repair screw must be inserted in area (A) when door opener is installed.

Installation:

Catches (1) on door opener (2) must not be damaged.

Fig 3: Identifying Catches And Door Opener (2 Of 2)

G04728327

Courtesy of BMW OF NORTH AMERICA, INC.