51 21 330 Removing and installing/replacing window cavity cover strip on inner front door

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Front Door Trim Panel

Lever out cover (1) at rear slightly.

Start at rear with removal of window cavity cover strip (2).

Fig 1: Identifying Cover And Window Cavity Cover Strip

G04728336

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off window cavity cover strip (1) towards top.

Installation:

If necessary, replace faulty retainers (3).

Insert window cavity cover strip (1) below cover (2).

Fig 2: Identifying Window Cavity Cover Strip, Retainers And Cover

G04728337

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Coat window cavity cover strip (1) with water before fitting.

Start with installation at front.

Fig 3: Identifying Window Cavity Cover Strip

G04728338

Courtesy of BMW OF NORTH AMERICA, INC.