51 2. ... Removing window cavity cover strip with special tool 00 9 324 at front or rear

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 318
00 9 324

Open complete door window glass.

Front door:

Insert special tool 00 9 324 at front (at A-pillar) in window cavity (1) (letters TOP pointing upwards).

Rear door:

Insert special tool 00 9 324 at rear (at C-pillar) in window cavity (2) (letters TOP pointing upwards).

Fig 1: Identifying Special Tool (00 9 324) And Window Cavity

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For purposes of clarity, picture shows inner door panel and door window glass removed.

Special tool 00 9 324 must be correctly guided under window cavity cover strip (1).

2 Short leg, bottom
3 Long leg, top (TOP)

Fig 2: Identifying Window Cavity Cover Strip, Short Leg, Long Leg And Special Tool (00 9 324)
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Start at the front or rear, depending on the model.

IMPORTANT: Risk of damage!

Raise window cavity cover strip (3) no more than 5 mm in each levering operation, otherwise the strip will be bent.

Position special tool 00 9 318 on door trim panel (1).

Slide screwdriver (2) into special tool 00 9 324 and lever window cavity cover strip (3) upwards no more than 5 mm.

Guide special tools 00 9 324 and 00 9 318 towards front/rear and lever out window cavity cover strip (3) in the process.

Fig 3: Identifying Window Cavity Cover Strip, Door Trim Panel, Screwdriver, Special Tools (00 9 318) And (00 9 324)

Courtesy of BMW OF NORTH AMERICA, INC.