51 14 110 Removing and installing/replacing rear model designation (Brilliance)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The "Instructions For Number/Letter Combination Cementing " serve as the basis for these repair instructions and must be followed without fail.

Attach adhesive tape (1) between edge of rear lid (3) and top edge measurement "A".

Mark measurement "B" from outer edge of rear lid on adhesive tape (1) and stick on adhesive tape (2) vertically.

Measurements E60:

A = 18 mm

B = 38 mm

Measurements E90:

A = 25 mm

B = 46 mm

Fig 1: Identifying Rear Model Designation Fitting Dimensions (Brilliance)

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off liner (protective strip for adhesive surface).

Position characters on adhesive tapes (1 and 2) and stick into place.