51 00 ... Service position of engine hood/bonnet
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.
- 51 0 040
- 51 2 160
- 51 2 170
- 51 2 180
- 51 2 240
NOTE:
Only the special tool pertaining to the model series can be selected.
SPECIAL TOOL SPECIFICATION
| Model series | Special tool |
|---|---|
| E46, R50, R52, R53 | 51 2 160 |
| E53, E60, E61, E63, E64, E81, E85, E86, E87, E90, E91, E92, E93 | 51 2 170 |
| E65, E66, E67 | 51 2 180 |
| E83 | 51 0 040 |
| E70 | 51 2 240 |
WARNING:
Risk of injury and damage!
Engine hood/bonnet must be held by a second person helping.
NOTE:
The illustrations below serve as examples for all corresponding vehicles.
The operation is described on the left side; proceed in the same way for the right side.
Special tool can only be used on housing (1) of gas spring strut (thick part).
NOTE:
Gas spring strut can also be installed the other way round (housing on hood/bonnet).
Special tool can be used in both directions.
Special tool can be used in both directions.
Release Gas Spring Strut on left/right housing side.
Slide special tool (1) over housing (2) of gas spring strut.
Clip ball socket of special tool on ball stud.
Proceed in same way on other side.