52 26 311 Removing and installing/replacing lock for left or right rear seat backrest (through-loading system)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Unlock rear seat backrest and fold down.

NOTE: In event of faulty unlocking, perform Emergency Opening.

Unclip Bowden cable from holders (1).

Unfasten screws (2).

For tightening torque refer to 52 26 08AZ in 52 26 REAR SEATS (THROUGH-LOADING SYSTEM) .

Fig 1: Identifying Bowden Cable Holders And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull lock (1) out of installation opening slightly and unclip Bowden cable (2).

Remove lock completely from installation opening.

Fig 2: Identifying Bowden Cable And Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (2) on lock must not be damaged.

Bowden cable must be correctly anchored in catches (2).

Installation:

Slide guide lug (1) of lock into opening (2).

Fig 3: Identifying Lock Guide Lug And Opening

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting lock:

Slacken screws
Firmly push engaged backrest back
Tighten down screws