52 26 030 Removing and installing complete centre armrest for rear seat backrest (through-loading)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Unlock right backrest and tilt forwards.

Release screw.

For tightening torque refer to 52 26 03AZ in 52 26 REAR SEATS (THROUGH-LOADING SYSTEM) .

Open centre armrest (1) and remove.

Fig 1: Identifying Rear Seat Centre Armrest

G04727359

Courtesy of BMW OF NORTH AMERICA, INC.

Version "without skibag" only

IMPORTANT: Risk of damage!

Pull cover trim (1) at top edges in stages and unclip.

Installation:

Clips may remain in the backrest frame and must be removed.

Replace faulty clips.

Fig 2: Identifying Cover Trim

G04727360

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Forcefully pull top edge of cover trim (3) forwards and unclip upper retaining lug (1).

Unclip the four retaining lugs (2) in succession.

Fig 3: Identifying Cover Trim And Retaining Lugs

G04727361

Courtesy of BMW OF NORTH AMERICA, INC.

Pull cover trim (1) up and out of lower clips.

Installation:

Make sure cover trim (1) is correctly inserted into lower clips.

If necessary, replace faulty clips.

Fig 4: Identifying Rear Seat Cover Trim

G04727362

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Twist cover trim (1) out of lower retaining lug during removal.

Cover trim (1) must be replaced if retaining lugs are faulty.

Fig 5: Identifying Rear Seat Cover Trim

G04727363

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cover strip (1) from backrest frame.

NOTE: Cover strip (1) must be replaced if retaining lugs are faulty.

Fig 6: Identifying Rear Seat Cover Strip

G04727364

Courtesy of BMW OF NORTH AMERICA, INC.