52 24 400 Replacing seat cover for rear seat

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

52 0 050

Necessary preliminary tasks:

Remove Rear Seat

Unclip Isofix protective caps.

Installation:

Make sure Isofix protective caps are correctly engaged.

Fig 1: Identifying Rear Seat Isofix Protective Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out welt in area (1) with plastic wedge.

Unhook seat cover in area (2).

Fig 2: Identifying Welt And Rear Seat Cover Area

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and padding:

Release all retainers in marked area.
Remove seat cover from padding.
Remove remaining retainers from cover and padding

Fig 3: Identifying Rear Seat Cover And Padding Retainers Mark Area
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert new retainer (2) with special tool 52 0 050 and bend closed.

Padding
Retainer
Trim thread in padding
Trim thread in seat cover
Seat cover

Fig 4: Identifying Retainer, Padding, Seat Cover And Special Tool ( 52 0 050)
Courtesy of BMW OF NORTH AMERICA, INC.

Replacing cover:

Pull all trim wires out of seat cover
If necessary, cut in take-up for trim wires of new cover
Push trim wires into new seat cover

Fig 5: Identifying Rear Seat Cover Trim Wires

Courtesy of BMW OF NORTH AMERICA, INC.