61 31 270 Removing and installing/replacing switch for reversing light (DME)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The installation location of the reversing light switch can vary, depending on the transmission model.

Necessary preliminary tasks:

If necessary, remove Rear Underbody Protection

Version A:

Disconnect plug connection (1).

Release switch for reversing light (2).

For tightening torque refer to 61 31 2AZ in 61 31 SWITCH .

Fig 1: Identifying Version A Plug Connection And Reversing Light

Courtesy of BMW OF NORTH AMERICA, INC.

Version B:

Disconnect plug connection (1).

Release switch for reversing light (2).

For tightening torque refer to 61 31 2AZ in 61 31 SWITCH .

Fig 2: Identifying Version B Plug Connection And Reversing Light

Courtesy of BMW OF NORTH AMERICA, INC.