00 00 ... Engine oil service
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2008 BMW 328xi, 2008 BMW 328i, 2008 BMW 323i, 2007 BMW 335xi, and 2007 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.
Carry out oil service at normal operating temperature.
First replace oil filter, then change oil.
Clean sealing surfaces.
Add engine oil in accordance with inspection sheet.
Run engine at idle until oil level and oil pressure warning lamps go out.
Check oil filter housing and oil drain plug for leaks.
Switch off engine, check oil level, correct if necessary (car must be on a horizontal level surface).
Remove any oil traces.
Fill out oil documentation.
Repair instructions:
NOTE:
Advise customers of any changes in engine oil (e.g. fuel or water in oil).
For details on how to proceed, refer to
Repair instructions:
Engine oil service