65 77 601 Replacing sensor mat for front passenger seat occupancy detector (sport seat)

Front passenger seat US/CDN version (with OC3 mat) only: 

New seat cover must be completely installed with padding, seat heating and OC3 mat.

Release seat occupancy detector: 

• Connect diagnosis system
• Release seat occupancy detector
• Clear fault memory if necessary

Necessary preliminary tasks: 

• Remove Seat Cover For Right Front Seat

Disconnect plug connection (1).

Fig 1: Identifying Sensor Mat Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Cut front sticking surface in area (4) on sensor mat (1) with cutter knife or razor blade from foam without damaging the foam.

Remove sensor mat (1) and feed out electric lead.

Installation: 

In order to guarantee the function and fastening (adhesive strength) at the sticking surfaces of sensor mat (1), the foam most not show any traces of damage at all!

Replace the foam if it is hardened or damaged particularly in the area of the sticking surfaces.

Align new sensor mat (1) to upholstered seat section.

First guide cable through upholstered seat section in area (2).

Fig 2: Identifying Sensor Mat, Cable, Secure Area And Adhesive Strips

Courtesy of BMW OF NORTH AMERICA, INC.

Secure sensor mat in area (3) and align again.

Pull off adhesive strips in area (4) and stick to upholstered seat section.