65 50 011 Removing and installing (replacing) video module for on-board monitor

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2008 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection) .

Necessary preliminary tasks:

Disconnect Battery Negative Lead
Remove Luggage Compartment Trim on left.

NOTE: Follow instructions for Handling Optical Fibres .

Unfasten screws (2) and nuts (3).

Pull back video module for on-board monitor (1) and disconnect plug connections.

Remove video module for on-board monitor (1) complete with holder.

Fig 1: Identifying Video On-Board Monitor Module, Nuts And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (3) and remove holder (2) from video module for on-board monitor (1).

Fig 2: Identifying Video On-Board Monitor Module, Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding.