84 11 519 Removing and installing/replacing eject box

WARNING: This page is about a different car, the 2006 BMW 330xi, 2006 BMW 330i, 2006 BMW 325xi, and 2006 BMW 325i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340

Pull off gaiter (1) towards top.

Disconnect plug connection (2).

Fig 1: Disconnect Plug Connection

Snap out eject box (1) with special tool 00 9 340 on inner side of trim (2).

Pull eject box (1) on inner side upwards slightly.

Fig 2: Identifying Eject Box And Trim

Snap out eject box (1) with special tool 00 9 340 on outer side of trim (2).

Lift out eject box (1) and feed out cable.

Fig 3: Identifying Special Tool, Eject Box And Trim

Installation:

Catches (1) on trim (2) must not be damaged or missing.

Fig 4: Identifying Catches And Trim