General information:

WARNING: This page does not describe the selected car, but rather 228 other vehicles, including the 2013 BMW X6, 2012 BMW X6, 2012 BMW 750i, 2012 BMW 750Li, and 2011 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

General information for Service staff on the Run Flat Indicator The following general information on the Run Flat Indicator (RPA) is given for Service staff:

Wheel-Speed Sensor Failure
Read Off Status Of Initialization Phase

Wheel-Speed Sensor Failure If no signal is received from one of the wheel-speed sensors, the RPA will switch to "inactive" mode after approx. 2 minutes. The RPA indicator and warning light lights up yellow. The fault is indicated with a check control message. A fault is recorded in the fault memory of the RPA control unit.

If the RPA is integrated into the DSC, a fault will be recorded in the DSC control unit. If the signal returns after a signal failure, the RPA will be active again after driving for approx. 30 minutes. The fault will remain stored in the fault memory.

Read off status of initialization phase The status of the initialization phase can be displayed in the service functions for the control unit concerned (e.g. DSC control unit).