11 65 Turbocharger and control
TURBOCHARGER AND CONTROL
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Turbocharger to exhaust manifold | N14 | M8 nut - 10.9 | 20 Nm | |
| 2AZ Stud to turbocharger | N14 | M8 x 125 | Hexagon nut | 15 Nm |
| 3AZ Bracket to turbocharger | N14 | M8 | 25 ± 6 Nm | |
| 4AZ Oil feed to turbocharger | N14 | Banjo bolt M12 x 1.5 | 30 Nm | |
| 5AZ Oil return to turbocharger | N14 | M6 x 100 | 8 Nm | |
| 6AZ Bracket to crankcase | N14 | M8 x 125 | 19 Nm | |
| 7AZ Front heat shield to rear heat shield | N14 | M6 x 100 | 4 Nm | |
| 8AZ Coolant inlet and outlet lines to turbocharger | N14 | M14 x 1.5 banjo bolt | 4 Nm |