37 14 512 Replacing rear ride-height sensor
IMPORTANT:
Observe safety instructions for raising the vehicle, see LIFTING VEHICLE WITH A LIFTING PLATFORM
NOTE:
Tightening torques:
- Ride-height sensor holder on rear axle carrier: 7.6 Nm
- Jointed rod to holder: 7.2 Nm
- Holder to upper control arm: 6 Nm
IMPORTANT:
Read and comply with NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
Necessary preliminary tasks:
- Partially detach underbody panelling
Disconnect plug connection (1).
Release nut (2) and remove jointed rod from sensor lever (3).
Installation:
Replace self-locking nut.
Sensor lever (3) must point from ride-height sensor to lower control arm.
Tightening torque: 7.2 Nm
Release screws (1) and remove ride-height sensor.
Installation:
Tightening torque: 4.4 Nm
After installation:
- Check HEADLIGHT ADJUSTMENT , correct if necessary