67 62 ... Notes on initializing power window unit (front)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Initialization
for a MINI merely involves normalization
, i.e. the mechanical end stop of the power window unit is recorded and stored. Learning the characteristic curve
is not required due to the lack of an anti-trapping mechanism.
NOTE:
An initialization must be performed:
- In the event of malfunctions, e.g. no one-touch function or no complete closing of the door glass after closing of the door.
- After disconnection of the battery negative lead.
- After replacement of the flat motor/power window unit.
- After work is carried out on the power window mechanism.
WARNING:
No anti-trapping mechanism!
NOTE:
Performing initialization:
- The reference point for initialization is the mechanical stop with the door closed and the window in its uppermost position.
- To initialize, raise the window glass and keep the switch depressed in the Lift position for approx. 5 seconds and then release.
- Checking initialization:
- Open door, window glass move down slightly.
- Close door, window glass moves into "Closed" position.