51 14 002 Removing and installing/replacing front MINI badge

Special tools required:

00 9 322 . See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS -- S CLUBMAN .

IMPORTANT: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

NOTE: The MINI badge is damaged when removed and must be replaced.

Removing badge:

Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322.

Fig 1: Identifying Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Fitting badge:

Pull liner* off adhesive tape (1), position badge over guide pins (2) on hood/bonnet and press down firmly.

* Liner is the protective film on a new badge.

Fig 2: Identifying Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.