11 11 Engine Block
TIGHTENING TORQUES SPECIFICATION - ENGINE BLOCK
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Main bearing screws, observe tightening specification. | N12 | M9x115 | Replace screws | |
| Jointing torque | 30 Nm | |||
| Torque angle | 150° | |||
| 2AZ Bedplate, observe tightening specification. | N12 | M6 | Replace screws | |
| Jointing torque | 9 Nm | |||
| 3AZ Screw plug, timing case upper section | N12 | M22x1.5 | 50 Nm | |
| 4AZ Screw plug, timing case lower section | N12 | M16x1.5 | Replace seal | 30 Nm |
| 5AZ Oil baffle to crankcase lower section | N12 | M6x100 | 10 Nm | |
| 6AZ Screw plug, timing case lower section | N12 | M16x1.5 | Replace seal | 30 Nm |
| 7AZ Screw plug, timing case lower section | N12 | M16x1.5 | Replace seal | 30 Nm |