LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper Clubman, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Engine Electrical System - Repair - R55 (N12) >> Electronic Switching Or Control Unit >> 12 14 550 Replacing control unit (DME)

12 14 550 Replacing control unit (DME)

Necessary preliminary tasks: 

IMPORTANT: Follow instructions for removing and installing electronic control units.  See MODULES .
IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).  See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
NOTE:
  • Connect diagnosis system
  • Read fault memory.
  • Check stored fault messages
  • Rectify faults
  • Clear fault memory

Version 1: 

Unlock and remove cover (1).

Fig 1: Identifying Cover
G04796427Courtesy of BMW OF NORTH AMERICA, INC.

Version 2: 

Release screw (1) at side.

Unlock clamps and remove cover.

Fig 2: Locating Screw
G06907343Courtesy of BMW OF NORTH AMERICA, INC.

All Versions 

Unlock plug (1) and remove.

Fig 3: Identifying Plug
G04796428Courtesy of BMW OF NORTH AMERICA, INC.

Press locks in direction of arrow and remove control unit (2) towards top.

Locks are accessible through bores (1).

Fig 4: Removing Control Unit
G04796429Courtesy of BMW OF NORTH AMERICA, INC.
NOTE:
  • Check stored fault messages
  • Clear fault memory
scientia non olet · About LEMON Manuals